:	Mar 30, 2006

:

The crankshaft rear seal and retainer plate are supplied as an assembly and cannot be serviced separately.

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the CKP sensor ring.

.

Remove the crankshaft retainer plate.   Remove the 14 bolts.

.

: Oil seals must be fitted dry.   : Tighten the bolts securing the seal retainer to the cylinder block first. Install the crankshaft retainer plate.   Clean the component mating faces.   Install the seal retainer with its protection sleeve onto the crankshaft.   Locate the seal retainer onto the sump flange.   Engage the seal retainer dowels with the cylinder block and lightly tighten 2 bolts on opposite sides of the retainer.   Remove the seal protection sleeve.   Install remaining bolts and tighten all bolts evenly to 10 Nm (7 lb.ft).

.

Install the CKP sensor ring to the crankshaft.

.

Connect the battery ground cable.